Pressure Roller Dies

Rated 5.00 out of 5 based on 2 customer ratings
(2 customer reviews)

$49.00

Clear
SKU: N/A Category:

Description

If you are tired of having your pressure die flip or you want to have a nicer surface finish on your bent tube, you should swap your pressure die (right in image) for a roller die (left in image). This makes no changes to the alignment in the machine.

Why would I want this: It greatly speeds up loading the machine and also reduces friction on the dies, making lubrication not necessary and also potentially improving bend quality slightly. They are great for STEEL, ALUMINUM, and STAINLESS. They also allow you to pull bends up to 20+ degrees through them to make “S” bends and bends very close together if you’re careful.

Why wouldn’t I want this: If you are on a tight budget. These upgrades are not necessary to bend tube. Other than their modest cost, there are ZERO drawbacks to this upgrade.

5
Rated 5 out of 5
100 %
2
4
Rated 4 out of 5
0 %
0
3
Rated 3 out of 5
0 %
0
2
Rated 2 out of 5
0 %
0
1
Rated 1 out of 5
0 %
0

2 reviews for Pressure Roller Dies

Carl
Rated 5 out of 5
If you are on the fence about getting one of these vs the standard block go with the roller pressure die. It makes loading the machine so much easier by yourself.
Jason
Rated 5 out of 5
Just ordered these for 1.5 and 1.75 last week, fast sipping, used the 1.75 today and the tube bent great. Seemed like it was a little easier for the machine too.
Add a review

Your email address will not be published. Required fields are marked *